UNI-1045FC
Cadmium Free 45% Silver Solder
|
 |
-
High strength
-
Excellent capillary flow
- Very
low working temperature
- Good
corrosion resistance and conductivity
-
Ideal for Brass, Steel, Nickel and Copper Alloy
|
AG700 is
a high strength, flux coated, high silver bearing alloy which
provides excellent capillary flow at a very low working temperature.
AG700 has a good corrosion resistance and conductivity
For use on all ferrous and non ferrous (not white) metals. Ideal
for instrumentation, thin tubing, tool repairs and any delicate
type of work. Results are outstanding when used on stainless
steel. Also ideal for lap, tee, flange or square butt joints
and tool tipping. |
| Technical
Data |
| Nominal
Analysis |
|
| Tensile
Strength |
up
to 65,000 psi
|
| Working
temperature |
1125-1145°F
(607-618°C)
|
| Diameters
(in) |
1/16"
3/32"
|
| (mm) |
1.6
2.5 |
| |
|
|
| Procedure |
| Clean
work surface. Remove dirt, grease, rust, and burrs from joint
area. Joint fit-up should be .002" to .005" for best
results. In complex joint configurations, apply extra flux.
Use slightly carburizing flame. Melt off small quantity of flux
from rod and heat joint area. broadly, until flux liquifies.
Apply UNI-1045FC alloy as required to complete fillet. Keeping
the torch in motion will help prevent overheating. Remove flux
residue with hot water – 105°F (65°C) |
